Installation instructions for common model LED backlit signs

By | February 1, 2019
  1. Use the tape to stick the 1:1 layout template on the place you would install the LED backlit signs
  2. Drill the holes for the stud bolts and cable on the backing wall as the 1:1 layout template shows you
  3. Remove the 1:1 layout template from the backing wall
  4. Make the stud bolts holes be filled with structural adhesives
  5. Screw the stud bolts into the acrylic back-panel of the LED backlit signs 10mm~15mm
  6. Make the cables and the stud bolts through stainless steel tube spacers
  7. Make the cable of the individual part of the LED backlit signs through the cable holes
  8. Push the individual part of the LED backlit signage with the stud bolts into the stud bolt holes
  9. If you can work on the another side of the wall, it is best to use the washers and nuts to secure the stud bolts to the wall
  10. Link all cables together in parallel as the “WIRING DIAGRAM” shows you
  11. Link the cables of the LED backlit signs to the output of the AC transformer as the “WIRING DIAGRAM”  shows you
  12. Link the input of the AC transformer to your AC power as the “WIRING DIAGRAM”  shows you
  13. Turn on the AC power
  14. Using the nylon cable ties to make the cables to be well-organized

Leave a Reply

Your email address will not be published.